Hook up tachometer chevy

Hook up tachometer chevy


Hook up tachometer chevy

Instructions, mount the tachometer above the steering column or on the dashboard of your vehicle using the supplied hardware and tools recommended by the manufacturer. That's your tach signal hookup, handy and accessible.

In this instructable I online dating cards will show you how I installed an aftermarket tachometer on my 91 Chevy S-10. I always just used a lug terminal like you described, but if someone wanted to get fancy, I bet that factory style pigtail is available for a few bucks at most parts houses, too.

Reg: :23 AM, post#2167108, in response to, dD74Chevy. If your tachometer is not wired properly, it can cause melting and burning. John Dedicated Enthusiast Posts: 7196 Age: 49 Loc: Montgomery, AL Reg: :00 AM - Post#2167125 In response to DD74Chevy This is the wire Richard was talking about with the factory style connector on it: Link You might be able to get one in the help. And here I was gonna post a pic of the cover from a parts site; I skipped it because they just weren't that useful/clear. Thanks i appreciate. Dont know where on the HEI it goes to without pulling the cap anks in advance someotherguy, moderator, posts: 28777, age: 48, loc: Texas. Temp control where can i find a diagram of the vaccum hoses and where they hook up for the temp control on a 2000 chevy s10 read more.

Tachometers are a great tool for your vehicle if you enjoy monitoring your engine speed or idle. Car ran great then, I tried hooking up an autometer tach, Now when you start the car it lopes and surges, no vaccum lines are off.

Thanks again DD74Chevy Contributor Posts: 201 Loc: Idaho Reg: :21 PM - Post#2167349 In response to DD74Chevy No luck parts store didnt have. A tachometer is a tool which measures speed in revolutions per minute, or rpm, at which an engine shaft is rotating. Reg: :33 AM, post#2167115. Worked well for two years and then stopped working one day.

How to Wire an Electronic Tachometer as Easy as 1-2-3

On the coil of a 1987 Chevy R10 truck, where do you hook up a tach. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc. And i have a metal bracket that goes fron the hinge to the front to prevent the wrinkle.

Hook up the green wire to the negative side of the ignition coil, which is on the left side. This alone causes a lot of it also.

Related Chevy Questions 1999 Chevy s10: with a manual truck. Needless to say I didn't get a new tach along with the new distributor. Where does each wire go? Hard part was sifting thru the birds nest of wires to hook.

Close the hood, start the engine and test drive the vehicle make sure the tachometer is working. Here is what it lookes like when i had my engine apart DD74Chevy Contributor Posts: 201 Loc: Idaho Reg: :15 PM - Post#2168145 In response to Vaughn I believe those braces i have on it are saving it from bending. Post up some pics, we love 'em.

But the bracket is shot i think cant seem to line it up right at all. The S10 v6 ECM was re-flashed to know it has a vortec v8 in it and the engine management harness wa read more kalamykid, pactor automotive, vocational, Technical or Trade Scho 5,464 satisfied customers, chevy: is idling around 700 rpms but suddenly. Does the hood dating sites testimonials have the edge braces.

How to Connect a Tachometer to the Chevy 350 Our Pastimes

How much would it cost for a 2000 Chevy S10 pick up to have the left front ball joint replaced? Report Report Post" Post Quick Reply Print Topic Email Topic 26408 Views. Much appreciated it you guys!

This article on how to wire an electronic tachometer doesnt have anything to do with Project X other than that 57 is romantic dating the granddaddy to Super Chevys Chevelle. Where do i hook the green wire to? . I have a loose red wire with a bolt down lead next to the relay fuse box in the engine compartment. As for the hinges yes they wobble bad and i had the hood off when i replaced the lifters.

Have a 99 chevy express with.7. High School or GED 3,636 satisfied customers 2000 Chevy S10: pick up to have the left front ball joint replaced. It doesn't come straight down like most people try and shut them. I am trying to install an Autometer tach. JDSurge Forum Newbie Posts: 3 Reg: :54 PM - Post#2513348 In response to John Hi John. In response to, dD74Chevy Nice pic John. read more GM Tech (Cam) Chevy Technician Vocational, Technical or Trade Scho 15,756 satisfied customers Disclaimer: Information in questions, answers, and other posts on this site Posts comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts.

Hook up the red wire to the positive side of the ignition coil, which is on the right side. Dont know much about the motor yet.

Need a diffrent gear at the end. I want to hook up a tach to my 1995 chevy s-10 2x4, standard,.2 motor (4cyl). The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications hook up tachometer chevy of Experts. You hook the wire coming off the tach to your tachometer in your truck. Where do i post pictures so you guys and i can see my truck and other trucks?

Copyright © 2018-2019. - All Rights Reserved.